The installation of the Lava 20 System requires careful planning and execution to ensure optimal results. This comprehensive guide outlines the essential steps for installing Lava 20 on different surfaces, emphasizing the significance of following manufacturer guidelines for a successful waterproofing application.

Surface Preparation

Before applying the Lava 20 System, thorough surface preparation is imperative. Begin by inspecting the substrate to be waterproofed. Ensure it is clean, dry, and free from contaminants. Repair any existing damage, such as cracks or holes. Proper surface preparation is fundamental to achieving strong adhesion and a long-lasting waterproofing solution.

Application Of Lava 20

The method of applying the Lava 20 System can vary depending on the form of the product, whether it’s a liquid, membrane, or coating. Carefully follow the manufacturer’s instructions for the application technique. Pay attention to thickness and coverage rates to ensure the correct amount of material is applied.

Curing And Drying

After application, allow the Lava 20 System to cure or dry as per the manufacturer’s recommendations. This may involve maintaining specific environmental conditions, such as temperature and humidity. Proper curing is vital for the waterproofing system’s integri

Quality Control

Conduct a thorough inspection of the installed Lava 20 System to identify and rectify any defects, such as bubbles or pinholes. A high-quality installation is vital for reliable, long-term waterproofing performance.

Protection And Finish

Depending on the specific application and surface, additional protective coatings, finishes, or drainage systems may be required to enhance the Lava 20 System’s performance. These measures provide an extra layer of protection and extend the system’s lifespan.